Magna Jetting Systems

Details:

• Soft touch rubber grip.
• Nickel-plated brass body.
• Stainless steel inlet fitting

Features:

• Guns suitable for use up to 500 bar – 50 MPa rated pressure pumps.
• No fluid passage upon trigger release.
• New mechanical device with double connecting rods to guarantee less strain when opening and holding.
• Covered by shockproof plastic semi-housings.
• Seat in Sst and ball in Widia.
• Totally built in stainless steel AISI 303.
• Ergonomic construction.
• Minimum fatigue for trigger opening and use
• New mechanical opening device with double connecting rods
• New trigger design, rotating on a fixed pin to guarantee better mobility and steadiness
• The gun has been designed for continuous use, at a water temperature of 90°C (195°F). It can resist at the max
• temperature of 160°C (320°F) for short periods only, as, when the gun shuts off, the heater continues to transmit the heat
• to the water, thus increasing both temperature and pressure up to high, dangerous values.
• Using the gun at a water temperature higher than 60°C involves for the operator the use of adequate safety devices,
• such as gloves, glasses, etc.

An excellent gun for extended-time pressure washing jobs, this Mecline MV925 spraying gun boasts a trigger that is designed to significantly reduce hand fatigue and discomfort. This spray gun operates at a maximum pressure of 4500 PSI, a maximum flow rate of 8 GPM, and a maximum temperature of 320 degrees Fahrenheit